Izdelki za alko plus gumijot (2)

ECOFIX PLUS the best adhesive spray for printing boards ECOFIX PLUS is an high tack adhesive specially indicated for the textile silk-screen printing industry. It is suitable to keep the fabrics steady to their support while being printed. CHEMICAL BASE BASE: Synthetic rubbers and solid resins SOLVENTS: hydrocarbure group, benzen and omologous are absent PROPELLENT: Denaturate odourless hydrocarbure COLOUR: Yellow clear VISCOSITY: Middle IT DOES NOT CONTAINS CFC MAIN CHARACTERISTICS It does not transfer on the fabric or cloths printed. It does not dirty the fabrics. It is suitable for cotton, silk, wool, synthetic fabrics, cotton, mixed. It resists to many applications. It has a good resistance to heat. It is also suitable in embroidery industry to keep the cloth steady during embroidery. In the cut rooms it gets the adhesion of the model to the cloth during the cut. DIRECTIONS FOR USE Shake well the can before use. Spray the product from a distance of 25-30 cm. Remove it with wash solvent perchloroethylene.

An anti-dust chemical/mechanical revitalising hardener for concrete flooring and screeds, consisting of an aqueous solution of mineral silicates and fluosilicates, activated by specific wetting agents. It is applied in several coats of decreasing dilution in water, with a brush or mechanical “scrubber”. Specific anti-dust treatments for industrial flooring or concrete slabs that have lost their original “vitality”. It reacts with the calcium compounds, soluble and unstable, present in of concrete products, transforming them into new stable, insoluble and resistant compounds. Consequent increases in resistance to wear and tear of the order of 200% -400%, significant increases in chemical stability, resistance to freeze-thaw cycles etc. Reactive impregnations for stabilising chemical and mechanical structures and concrete products. Hardening, anti-dust, anti abrasive and anti-corrosion treatments for concrete floorings. Adjustment of the chemical and mechanical performance of products for the industrial, rural and livestock construction (on horizontal surfaces). Apply, preferably with a brush or with "washer dryer" machine on the basis of the following indications: - Porous surfaces: repeated applications of a solution of water and QL Fluosil at a ratio in 1:1 - Compact surfaces: apply three coats, with decreasing dilution with water. 1a coat 1:3, 2a coat 1:2, 3a coat 1:1. The consumption of QL Fluosil will be proportional to the absorption of the floor to be treated. Indicatively a porous surface will consume about 400 g/m², while a surface with normal porosity will consume 250-300 g/m². Leave the product to dry between one coat and the next and then, after the last coat, wash with copious amounts of water. Protect glass and aluminium surfaces during application. Application surfaces should be clean, free of soiling, crumbling and non-adhering parts, dust, etc., conveniently saturated with water until they reach the condition "saturated with dry surface".