Izdelki za cc150s fo 2v 2c (6)

The CLA TSF-000 through TSF-5 are bidirectional, inductive type torque sensors. The measurement system is composed of an axis mounted on flexible pivots with cruciform springs allowing frictionless torque measurement. The axis rotation angle measurement, which is proportional to the measured torque, is performed via an inductive displacement sensor with carrier frequency. The small rotation angle, approximately 1° for all measurement range, allows very good linearity and negligible hysteresis.

24VDC / 5VDC 10A

Elettropompe volumetriche periferiche in grado di sviluppare pressioni elevate in rapporto a portate e potenze modeste. Girante in ottone Tenuta meccanica in ceramica grafite Motore chiuso autoventilato Isolamento classe F Alimentazione monofase 230V50Hz con protezione termica e condensatore permanentemente inserito Alimentazione trifase 230/400 V50Hz con protezione a cura dell'utilizzatore Temperatura acqua max. 90°C Corpo pompa:ghisa Albero:acciaio inox AISI 416 Protezione:IP44 Pression max:6-8-9 bar

The CryLaS Q series lasers are diode-pumped solid-state lasers (DPSS lasers) based on a microchip design. This consists of an Nd:YAG resonator with a directly coupled saturable absorber which works as a passive Q-switch. The compact housing and easy operation make the lasers an optimum light source for applications that require minimal housing dimensions with highest performance. Based on the 1064 nm fundamental, harmonics are generated using non-linear (NLO) crystals that allow a wide spectrum of laser wavelengths from 1064 nm to 213 nm. The FQSS213-Q4 laser emits pulses with approximately 1 ns pulse width at 213 nm, and can be modulated from single shot to 1 kHz. The pulse energy is 2.5 µJ. CryLaS lasers impress with their easy installation, service-free operation and long service life. This makes them ideal for OEM applications and demanding laboratory setups. Wavelength:213 nm Pulse energy:2.5 µJ Peakpower:2.5 kW Pulse Width:1 ns Average Power:2.5 mW Repetition Rate:1 kHz Beam diameter:< 0.45 mm Spatial Mode:TEM00 Application:Holography, engraving, photo acoustics, LIBS, mass spectroscopy, photo luminescence

Trickle Long-life type 10-12 years, 12V, 20Ah, Maße 76,0 x 181,0 x 167,0mm

The CryLaS Q series lasers are diode-pumped solid-state lasers (DPSS lasers) based on a microchip design. This consists of an Nd:YAG resonator with a directly coupled saturable absorber which works as a passive Q-switch. The compact housing and easy operation make the lasers an optimum light source for applications that require minimal housing dimensions with highest performance. Based on the 1064 nm fundamental, harmonics are generated using non-linear (NLO) crystals that allow a wide spectrum of laser wavelengths from 1064 nm to 213 nm. The FQSS213-Q1 laser emits pulses with approximately 1 ns pulse width at 213 nm, and can be modulated from single shot to 20 kHz. The pulse energy is 0.05 µJ. CryLaS lasers impress with their easy installation, service-free operation and long service life. This makes them ideal for OEM applications and demanding laboratory setups. Wavelength:213 nm Pulse energy:0.05 µJ Peakpower:0.05 kW Pulse Width:1 ns Average Power:0.75 mW Repetition Rate:20 kHz Beam diameter:< 0.4 mm Spatial Mode:TEM00 Application:Holography, engraving, photo acoustics, LIBS, mass spectroscopy, photo luminescence