Izdelki za cevasti grelniki (4)

Screw-in Tubular Heaters are the standard solution for all heating processes with liquids or gas. The heater is installed in a tank or a tube system by the G1½" screw fitting. The IP54 connection head, fitting and tubular heater consists of stainless steel. The tube sheath material 1.4529 is resistant to sulphite, phosphors and hydrochloride media. Type:without controller and limiter Type:with controller (adjustable from 30 ° to 85 °C, freezing protection at 7 °C) Type:with limiter (adjusted to 110 °C) Type:with controller-limiter-combination

Hochleistungsfeuer

Square stainless steel tubular heaters BASE-flex (1.4541) are a reliable industry standard for the use in heating platens and manifolds. In contrast to traditional tubular heaters with a round section which have to be bent by machines, square BASE-flex can be fitted into any rectangular groove with simple hand tools. Moreover, the square shape results in a bigger heat emitting area of up to 80% compared with a corresponding round section. Finally, the easy manual mounting saves the usually high technical expenditure for casting-in / soldering / cementing of bent round tubular heaters. A soft version of the BASE-flex, the NICKEL-flex (2.4068) is available as special execution. Due to the soft, easy to form nickel material, the NICKEL-flex is suitable for manual mounting with hand tools in round sections, too. Furthermore, Nickel has a better capability to conduct heat compared with stainless steel. Wattage:+ 5% - 10% Resistance:+ 10% - 5% dielectric strength:1500 V Insulation (cold 1000 V DC):> 10 MΩ Leakage current (cold):< 0,5 mA Maximum working temperature :750 °C Length tolerance:± 2% (min. ± 5 mm)

Finned Tubular Heaters are the ideal solution for air or gas flow heating processes. The ribs enlarge the heat-releasing surface significantly. Basis of the finned tubular heaters are our 8.5 mm tubular heaters. The outer diameter of the fins is 28 mm. The elements can be delivered straight, U-shaped or circular (special design on request). Tubular heater as well as fins are made of stainless steel, the standard for the tube is 1.4828 (other materials possible as in chapter Round Tubular Heaters), the fins are normally made of 1.4301 (1.4571 on request). Terminations for finned heaters::6,3 mm blade terminal Terminations for finned heaters::M4 threaded pin Terminations for finned heaters::With fibreglass leads